Hi. The download link to the zip file that had the firmware update script was wrong. It now been corrected so please download the latest zip file an...

Hi Marco. From what i remember, the adapter on Mister FPGA will only work with 2 paddles and for older firmware like 8.5, you need to connected the ...

It works fine. Try following steps on this video

Hi there. The Atari800 emulator only supports paddles using mouse emulation. So what you need to do is put the iCode device into mouse mode. P...

Hi, even on the small screen you dont see movement? make sure the paddles are turned clockwise (to the right) all the way, then trun off the deevice...

Hi. I assume you see movement on the small screen correctly when you move the stick? I tried both Vice and VirtualC64 mulators on my Macbook run...

I remember I tried it several months ago and it was working but I don't remember if i did any special configs. Its most likely just a config issue. O...

Thanks for the suggestion. We will certainly consider it. the challenge with the current model is its reached it capacity for firmware size so adding ...

Hi. Are you using the quad plus with LCD screen? if so, do you see any movement on the screen as you try to use the trackball? please try each o...

Hi. interesting issue. The range the iCode quad reports to Linux is {-32767, 0, 32767) when the stick as setting on the device is set to Left or Ri...

Glad its back to working! Yes, the newer firmware is too large so there is no space for standard bootloader so the system will not see it as com port...

@galaxxian looks like the unit is in Genesis mode and paddles forced on in settings. Try this. Flash the normal H11907 firmware and press the ...

I see. And what is the issue when you tried the DuoPlusH11V907 ?

Hi. I assume you have the version where the there are two rows of 3 buttons? Try this firmware:

please try the manual process shown at the bottom of this page. under section: "Force Update without PROG – Command Line Only"