Notifications
Clear all
Topic starter
21/10/2026 9:26 am
I just got the Icode duo 5200 Ultimate h1, and tried plugging in my 5200 controllers. The screen just says "connect controllers" as if nothing is plugged in. When i use the browser based tester, some of the keys work but the joystick controller doesn't do anything and half the numbers do nothing. So it seems as if the input is recognized but not properly.. i have two controllers and they both are recently restored and both act the same.
even though the icode says "connect controllers" it seems to be partially recognized and these are how the controls seem to be mapped on the live input visualization app:
start button: select/8
pause button: nothing
reset button: analog stick/8
1: x/0
6: left shoulder
*: 9/start
other numbers: nothing
right and left top buttons: o/1
right and left bottom buttons: x/0
Help!!
21/10/2026 10:33 am
Hi. If the unit does not detect the analog stick, the display wont change. Something is wrong either with controller or the detection. Try the diagnostics in the menu and turn on analog data to on and exit the menu. if you dont see any numbers come up at the bottom of the screen, then the wires on your controller or pots are not functioning.
21/10/2026 11:27 am
One other thing you can do is wet your thumb and press it against the port pins and the unit will think there is a controller connected. if your wet thumb activates the screen like its connected, then you know you have a bad controller.